®
photoLab
6100 VIS
Battery service life
ba75847e06
06/2013
3.3
Initial commissioning
Perform the following activities:
Insert the buffer batteries (see section 3.3.1)
Connect the power supply (see section 3.3.2)
Switch on the photometer (see section 3.3.3)
Set the language (see section 3.3.4)
Set the date and time (see section 3.3.5)
Carry out a zero adjustment (see section 4.4)
Note
When you set the language, date and time according to the mentioned sec-
tions of this operating manual you will quickly become familiar with the simple
operation of the photoLab
tion are given in section 4.2 G
3.3.1
Inserting the buffer batteries
The buffer batteries supply the integrated clock while the photometer is
switched off. Four alkaline manganese batteries (type AA or Mignon) sepa-
rately included in the scope of delivery are used as the buffer batteries.
Insert the batteries as follows:
1
The power consumption of the clock is very low. The lifetime of high quality
batteries is at least 5 years.
®
6100 VIS. More detailed instructions on opera-
ENERAL OPERATING PRINCIPLES
1 Turn the photometer upside down
and place it on a soft surface.
2 Open the lid of the battery com-
partment (1).
3 Insert the four batteries in the bat-
tery compartment. Make sure that
the poles of the batteries are in the
correct position.
The ± signs on the batteries must
correspond to the ± signs in the
battery compartment.
4 Close the lid of the battery com-
partment.
Commissioning
.
17