Table of Contents
Advertisement
Cutting Tips
•
Before each operation, remove cut-offs from
machine.
•
Never place hands/fingers under blades. Use
a push stick or other tool to clear small cut-
offs. Always turn machine OFF and discon-
nect power to clear around cut-off pieces.
Use of hand tools is intended to prevent need
for operator to place hands or fingers within
shear point-of-operation.
•
Keep the upper blade properly adjusted to
the lower blade (refer to Adjusting Blade
Gap on Page 38 for detailed instructions).
This will help ensure good cutting results and
avoid blade damage.
•
Make sure both side work stops are square
with the blades.
•
Always check the workpiece position before
engaging the shear. If it is correct, press the
foot pedal to make the cut.
-26-
Cutting Procedure
The Model G0845P can cut up to 10-gauge mild
sheet steel and 8-gauge sheet aluminum. Two
blade gap adjusters on the back of the shear allow
quick adjustment of the blade gap to accommo-
date different workpiece thicknesses. ALWAYS
set the blade gap adjusters equally.
The shearing action of the blades works similarly
to a pair of scissors (see illustration in Figure 29).
Shearing Action
Lower Blade
Figure 29. Blade shearing action.
Items Needed
Sheet Metal Gauge ........................................... 1
Wrench or Socket 25mm ................................... 1
The shear blades or hold-
down can easily pinch,
crush, or amputate fingers
or other body parts. Always
keep hands, fingers, and
other body parts clear of
blades and hold-down dur-
ing operation.
Bodily injury can result from improper use
of this machine. Always wear safety glass-
es, leather work boots, and heavy leather
work gloves when operating this machine or
whenever handling sheet metal.
Model G0845P (Mfd. Since 01/18)
Qty
Advertisement
Table of Contents
