Table of Contents
Advertisement
Rear Work Stop Support Rods
Lubrication Frequency ..................... Every Month
Keep the rear work stop support rods lubricated
for smooth operation.
Items Needed
Stiff Cleaning Brush .......................................... 1
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
NLGI#2 Grease or Grizzly T26419 .... As Needed
ISO 68 Oil or Grizzly T27914 ............. As Needed
To lubricate rear work stop support rods:
1.
DISCONNECT MACHINE FROM POWER!
2.
Use mineral spirits and stiff cleaning brush to
clean gear racks on bottom of support rods
(see Figure 46).
Figure 46. Rear work stop support rod
lubrication.
3.
Wipe support rods clean with mineral spirits.
Allow to air dry.
4.
Apply light coating of ISO 68 machine oil or
equivalent on upper surface of support rods.
5.
Apply light coating of NLGI #2 grease or
equivalent to gear racks.
6.
Move work stop assembly across support rods
several times to evenly distribute lubricant.
-34-
Qty
Support Rods
ON
OFF
Gear
Racks
Connecting Rod Pin Shafts
Lubrication Frequency ..................... Every Month
The connecting rods transfer power between
the eccentric cams and upper blade frame. The
pin shaft links the connecting rod with the upper
blade frame.
Items Needed
Grease Gun ....................................................... 1
NLGI#2 Grease or Grizzly T26419 .... As Needed
Shop Rags ......................................... As Needed
To lubricate connecting rod pin shafts:
1.
DISCONNECT MACHINE FROM POWER!
2.
Clean area around grease fittings on bottom
of blade frame where shown in Figure 47.
Connecting
Rod Grease
Fittings
Figure 47. Connecting rod lubrication.
3.
Pump in new grease until it just seeps from
fitting. Repeat for second grease fitting.
4.
Run machine through several cutting cycles
to evenly distribute grease.
Main Shaft Roller Bearings
Lubrication Frequency ................ Every 6 Months
Grease the four main shaft roller bearings when-
ever changing the gearbox oil.
Items Needed
Grease Gun ....................................................... 1
Hex Wrench 4mm .............................................. 1
Shop Rags ......................................... As Needed
NLGI#2 Grease or Grizzly T26419 .... As Needed
Model G0845P (Mfd. Since 01/18)
Qty
ON
OFF
Qty
Advertisement
Table of Contents
