Grizzly G0845P Owner's Manual page 29

To cut a workpiece:
1. Measure workpiece for thickness and mark
for length of cut.
2. Set blade gap
match workpiece material thickness (see
Figure 30).
IMPORTANT: DO NOT exceed maximum
blade gap measurements listed on adjusters.
Blade
Gap (in.)
0.017
0.015
0.010
0.005
0
0.025 0.050 0.075
Sheet Thickness (in.)
Blade Gap
Adjuster (1 of 2)
Figure 30. Measure workpiece, then set both
blade gap adjusters according to chart.
Model G0845P (Mfd. Since 01/18)
adjusters equally
Material
Stainless Steel
Mild Steel
Aluminum/
Copper
0.100
0.125 0.150
3. Use scale and magnifier on rear work stop
assembly to set workpiece depth of cut (see
Figure 31), then tighten lock handles.
Lock Handle
to
Figure 31. Rear work stop assembly features.
4. Square workpiece against left work stop, then
push workpiece against rear work stop, as
shown in Figure 32.
Left Work Stop
Rear Work Stop
Figure 32. Properly placing workpiece against
left work stop and rear work stop for cut.
Magnifier Scale
-27-