Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for cutting.
2.
Sets blade gap adjusters equally to suit
workpiece gauge and material.
3.
Uses appropriate tools to place and remove
materials in machine point-of-operation.
4.
Adjusts rear work stop for length of cut.
5.
Turns machine ON and uses shear switch to
select foot switch cutting operation.
6.
Puts on safety glasses, leather boots, and
heavy leather gloves.
7.
Places workpiece on front support rods and
up against left side work stop.
8.
Slides workpiece under blade and up against
rear work stop.
9.
Presses foot pedal to make cut.
10. Removes workpiece and cut-off piece, or
repeats Steps 7–9 to make additional cuts of
same length.
Model G0845P (Mfd. Since 01/18)
To reduce your risk of
serious injury, read this
entire
using machine.
Bodily injury could result from using this
machine. Always wear safety glasses,
leather work boots, and heavy duty leather
work gloves when operating this machine
or whenever handling sheet metal.
The shear blades or hold-
down can easily pinch,
crush, or amputate fingers
or other body parts. Always
keep hands, fingers, and
other body parts away from
the blades and hold-down
during operation.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
11. Turns machine OFF when operation is
complete.
manual
BEFORE
-25-
Advertisement
Table of Contents
