Grizzly G0845P Owner's Manual page 37

To lubricate main shaft roller bearings:
1. DISCONNECT MACHINE FROM POWER!
2. Remove front cover.
3.
Remove dust cap and clean grease fitting,
then pump in new grease until it just seeps
from fitting (see Figure 48). Repeat for all (4)
bearings.
Main Shaft
Main Shaft Roller Bearings
Figure 48. Main shaft roller bearing lubrication.
4. Replace front cover.
5. Run machine through several cutting cycles
to evenly distribute grease.
Gearbox Oil
Lubrication Frequency ................ Every 6 Months
Change the gearbox oil whenever greasing the
main shaft roller bearings.
Items Needed
Drain Pan 1 Gallon ............................................ 1
Hex Wrench 4mm .............................................. 1
Open-End Wrench 17mm .................................. 1
Shop Rags ......................................... As Needed
ISO68 Oil or Grizzly T27914 .............. As Needed
To change gearbox oil:
1.
DISCONNECT MACHINE FROM POWER!
Model G0845P (Mfd. Since 01/18)
2. Remove front cover and rear cover.
3.
Working at front of machine, place drain pan
under gearbox drain plug (see Figure 49).
ON
OFF
Figure 49. Gearbox drain plug and sight glass
4.
Remove drain plug and allow oil to drain, then
clean drain plug opening, re-install drain plug,
and carefully remove drain pan.
5.
Working at rear of machine, remove fill plug
(see Figure 50).
Note: The fill plug is made of plastic. Be care-
ful if using a wrench to remove it.
Fill Plug
Qty
Figure 50. Gearbox fill plug (rear of machine).
6.
Fill gearbox with ISO 68 machine oil or equiv-
alent until oil level is centered in sight glass
(see Figure 49), then re-install fill plug.
7.
Replace front and rear covers.
(front of machine).
ON
OFF
Sight
Glass
Drain
Plug
-35-