Table of Contents
Advertisement
8.
Put stop block finger in up position when not
in use (see Figure 34).
Figure 34. Moving stop block finger to up
position.
Workpiece Support Rod Work Stops
Each workpiece support rod has an adjustable
work stop. After the workpiece slides over the
work stop, a raised edge flips up to support the
back of the workpiece. Each work stop can be set
from 5
⁄
" to 37" away from the blade.
1
8
Items Needed
Hex Wrench 5mm .............................................. 1
Machinist's Square ............................................ 1
To adjust and use workpiece support rod work
stops:
1.
Measure workpiece for length of cut or cuts.
Model G0845P (Mfd. Since 01/18)
2.
Loosen (2) cap screws on center workpiece
support rod work stop (see Figure 35). Move
work stop to match measurement taken in
Step 1, using machinist's square to align
raised edge with scale. Tighten cap screws.
Note: To make two cuts on one workpiece,
set right work stop to desired depth of cut by
following directions in Step 2.
Scale
Figure 35. Workpiece support rod work stop
3.
Push workpiece over middle work stop,
Qty
square workpiece with left work stop, then
pull workpiece back against raised edge of
work stop.
4.
Turn ON/OFF switch ON, then turn shear
switch to the right to select foot pedal
operation.
5.
With hands and fingers clear of blade area,
press foot pedal to cut workpiece.
6.
To make second cut on workpiece, repeat
Steps 3–5 using right work stop.
Cap Screws
Raised
Work
Edge
Stop
adjustments.
-29-
Advertisement
Table of Contents
