Assembly - Grizzly G0845P Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
The G0845P comes mostly assembled from the
factory. The rear work stop assembly, left work
stop, workpiece support rods, and control pedes-
tal must be assembled or attached.
Items Needed
Hex Wrench 6mm .............................................. 1
Open-End Wrench 25mm .................................. 1
Another Person .................................................. 1
To assemble machine:
1. With help from another person, lift rear work
stop assembly and place support rods in
mounting holes on upper blade frame (see
Figure 16). Secure with (2) M16-2 x 25 hex
bolts and (2) 16 x 44 x 6mm dock washers.
Mounting Holes
x 2
Figure 16. Rear work stop assembly mounted to
upper blade frame.
-20-
Qty
Work Stop
Support Rods
Work
Stop
Assembly
2. Attach (2) workpiece support rods and left
work stop to table using (6) M8-1.25 x 16 cap
screws (see Figure 17).
Left
Work
Stop Support Rods
Figure 17. Workpiece support rods and left work
stop attached to table.
3. Plug foot pedestal wiring harness into electri-
cal box plug as shown in Figure 18. Thread
collar onto plug to secure.
Electrical
Box Plug
Collar
Figure 18. Connecting foot pedestal wiring
harness.
Model G0845P (Mfd. Since 01/18)
Table
x 6
Pedestal
Stand
Wiring
Harness