Grizzly G0845P Owner's Manual page 35

Upper Blade Frame & Gibs
Frequency ................ Every 8 Hours of Operation
Two grease fittings on the back of the upper blade
frame lubricate the front and rear gibs inside the
blade guides.
Items Needed
Grease Gun ....................................................... 1
Shop Rags ......................................... As Needed
NLGI#2 Grease or Grizzly T26419 .... As Needed
To lubricate upper blade frame and gibs:
1.
DISCONNECT MACHINE FROM POWER!
2.
Clean grease fittings on upper blade frame,
and wipe old grease off blade guides behind
gibs (see Figure 44).
Upper Blade
Blade Guides
Figure 44. Lubrication points for blade guides
and gibs (rear work stop removed for clarity).
3.
Pump in new grease just until it seeps from
fittings.
4.
Apply thin coating of grease on exposed
areas of upper blade frame and gibs.
5.
Run machine through several cutting cycles
to evenly distribute grease.
Model G0845P (Mfd. Since 01/18)
Qty
ON
Gibs
OFF
Grease
Fittings
Frame
Eccentric Cam Bushings
Frequency ........................................ Every Month
The eccentric cam transfers power from the motor
to the upper blade frame. The copper bushings
inside the cam require regular lubrication.
Items Needed
Grease Gun ....................................................... 1
Hex Wrench 4mm .............................................. 1
Shop Rags ......................................... As Needed
NLGI#2 Grease or Grizzly T26419 .... As Needed
To lubricate eccentric cam bushings:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove front cover.
3.
Clean each grease fitting, then pump in new
grease until it just seeps from cam bushing
housing and grease fitting (see Figure 45).
Eccentric
Cam Bushings
Figure 45. Eccentric cam bushing grease fittings
(front cover removed).
4.
Replace front cover.
5.
Run machine through several cutting cycles
to evenly distribute grease.
Qty
ON
OFF
-33-