Table of Contents
Advertisement
4.
Loosen (2) pressure regulating hex bolts at
end of hold-down clamp (see Figure 52).
Pressure-Regulating
Hex Bolts
Hold-Down Clamp
Figure 52. Pressure-regulating hex bolts on
hold-down clamp.
5.
Move rear stop assembly away from blades.
6.
To release motor brake, push lever right, as
shown in Figure 53, then turn drive pulley by
hand until upper and lower blades completely
overlap.
Drive
Pulley
Figure 53. Releasing motor brake to turn motor
by hand.
7.
Turn both blade gap adjusters counterclock-
wise to 0" setting (see Figure 54).
Scale Pointer
Set
Screw
Figure 54. Blade gap adjuster detail.
Model G0845P (Mfd. Since 01/18)
ON
OFF
Motor Brake Lever
Push to
Release
8.
Remove (4) plastic caps on side of frame
to expose blade guide eccentric cams and
blade guide retaining studs (see Figure 55).
Remove
Plastic
Caps
Figure 55. Location of covers for blade guide
eccentric cam and retaining stud (right side).
9.
Slightly loosen hex nuts on both blade guide
retaining studs, then loosen hex nuts on both
blade guides just enough to adjust eccentric
cams (see Figure 56).
Figure 56. Location of blade guide retaining hex
nut and eccentric cam (right side).
Blade Guide
Eccentric Cam
Blade Guide
Retaining Stud
-39-
Advertisement
Table of Contents
