Squaring Side Work Stops - Grizzly G0845P Owner's Manual

Squaring Side Work
Stops
The Model G0845P left and right work stops are
adjusted at the factory to be square, but they can
be adjusted if cutting operations are no longer
producing satisfactory results.
Items Needed
Hex Wrench 6mm .............................................. 1
Wrench or Socket 18mm ................................... 1
Magnetic Base Blocks (See Page 31) ............... 2
Carpenter's Square 16" x 24" ............................ 1
Squaring Left Work Stop
1.
Place upper blade at top dead center using
foot switch.
2.
DISCONNECT MACHINE FROM POWER!
3.
Place (2) magnetic base blocks 12" apart on
right side of lower blade (see Figure 65).
Magnetic
Base Blocks
Lower
Blade
Figure 65. Magnetic base blocks used to check
squareness of work stops.
4. Place carpenter's square against magnetic
base blocks and left work stop.
5. If square aligns with base blocks and left
work stop, no adjustment is necessary.
6.
If left work stop does not align with square,
loosen (2) cap screws securing work stop
to table and adjust work stop to align with
square. Tighten cap screws.
-44-
Squaring Right Work Stop
1.
Place upper blade at top dead center using
foot switch.
2.
DISCONNECT MACHINE FROM POWER!
3.
Place (2) magnetic base blocks 12" apart on
left side of lower blade (see Figure 65).
4.
Place carpenter's square against magnetic
base blocks and right work stop.
Qty
5.
If square aligns with base blocks and right
work stop, no adjustment is necessary.
6.
If right work stop does not align with square,
loosen (2) hex bolts securing work stop
to table and adjust work stop to align with
square. Tighten hex bolts.
ON
OFF
Model G0845P (Mfd. Since 01/18)