Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Box 1 (Figures 7–9)
A. Electric Shear ............................................. 1
B. Foot Pedestal Assembly ............................. 1
C. Rear Work Stop Assembly ......................... 1
D. Left Side Stop w/Flip Stop .......................... 1
E. Workpiece Support Rods ........................... 2
F.
Grease Gun ................................................ 1
G. Flat Head Screwdriver #2 ........................... 1
H. Adjustable Wrench ..................................... 1
I.
Hex Wrench Set 3, 4, 5, 6, 8, 10mm .....1 Ea
J.
Feeler Gauge Set ....................................... 1
K. Hardware Bag
—Hex Bolts M16-2 x 25 ............................. 2
— Dock Washers 16 x 44 x 6mm ............... 2
—Cap Screws M8-1.25 x 16....................... 6
-14-
Figure 7. G0845P electric shear and foot
Qty
Figure 8. G0845P rear work stop assembly.
D
F
G
Figure 9. G0845P inventory.
A
pedestal assembly.
C
H
I
J
Model G0845P (Mfd. Since 01/18)
B
E
K
Advertisement
Table of Contents
