Inventory - Grizzly G0604Z Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Crate Inventory (Figure 9)
A. Jointer Assembly ........................................ 1
Box Inventory (Figure 10)
B. Foot Pedal Assembly ................................. 1
C. Cutterhead Guard ....................................... 1
D. Rabbeting Table ......................................... 1
E. Indexable Carbide Inserts 14 x 14 x 2mm .. 3
Push Blocks ................................................ 2
F.
G. T-Handle Torx Wrenches T-20 ................... 2
H. Hex Wrenches 2.5, 4, 5, 6, 8mm ..........1 Ea.
Flat Hd Torx Screws T20 M6-1 x 15 ........... 5
I.
Open-End Wrenches 8/10, 12/14mm ...1 Ea.
J.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0604Z (Mfd. Since 02/24)
Qty
Qty
F
Figure 9. Crate inventory.
C
B
D
G
Figure 10. Box inventory.
A
E
H
I
J
-15-