Using Data Erase - Fluke Hydra Series II User Manual

Using Data Erase

Perform the procedure in Figure 3-9 to remove a data file from the memory card.
Removing a file does not interrupt the sequential dAtxx file names assigned with the
DATA OPEN command. When dAt99 is reached, the instrument will loop back and
reuse previously assigned file names that have been erased or skipped over. To exit at
any time (file not erased), press the C key.
FILES
ENTER
ENTER
ENTER
ENTER
Figure 3-9. Using DATA ERASE to Delete a Measurement Data File
Selecting the DATA mode. Press the FILES key
FILES
to access the FILES menu. Press the up/down
arrow keys until dAtA is displayed, then press the
Init
ENTER key. The menu changes to dAtA. If an
StAt
error message appears, see Table 3-1.
dir
dAtA
SEtUP
Selecting the ERASE mode.
dAtA
up/down arrow keys until ERASE is displayed in
the dAtA menu, then press the ENTER key. The
ErASE
menu changes to ErASE.
OPEn
Selecting a dAtxx File to ERASE. Press the
ErASE
up/down arrow keys until the dAtxx file to be
erased is displayed in the ErASE menu, where xx
dAt99
represents a number from 00 to 99, then press
dAtxx
the ENTER key. The menu changes to SUrE.
dAt00
Erasing a dAtxx File. Press the up/down arrow
SUrE
keys to select yES or no in the SUrE menu, then
press the ENTER key. yES will erase the file; no
yES
will cancel the procedure and nothing will be
no
erased.
ENTER, or displays nonE if there are no files to
erase. Press the CANCL key to exit. If an error
Typical
message occurs, see Table 3-1.
Required
Memory Card Operations
Data File Procedures
The procedure repeats after pressing
3
Press the
op45f.eps
3-13