Fluke Hydra Series II User Manual page 20

2635A
Users Manual
C
INTVL
CANCL
REVIEW
SHIFT
REVIEW
CANCL
D
Setting the Scan Interval. Press the INTVL key
SET
to open the interval menu. Up/down and left/right
arrow keys select 0:00:00 (default) to 9:99:99.
The format is HOURS:MINUTES:SECONDS.
0:00:00
The scan interval is the total time between the
start of each measurement cycle.
represents continuous scanning. Press CANCL
to exit. [Figure 2-11]
Selecting the Review Mode.
REVIEW
REVIEW key to open the Review array.
LAST MIN MAX
Review array holds the last, maximum, and
0
minimum readings during all previous scans for
all configured channels.
10
select the channel, while left/right arrow keys
select LAST, MAX, and MIN.
Review array, press the SHIFT key, release,
then press the REVIEW key. The Review array
is cleared automatically by changing any
parameter
Measurement Rate).
[Figure 2-18]
Select Channel 10. Select Channel 10 with the
CH
up/down arrow keys. [Figure 2-3]
20
...
10
...
0
Ten Minute Tour (cont)
xviii
Press the
Up/down arrow keys
To CLEAR the
on any channel (including
Press CANCL to exit.
0:00:00
The
op79_4f.eps