B
MON
MON
0
10
MON
SCAN
0
SCAN
10
SCAN
SHIFT
SCAN
0
SCAN
10
C
Selecting the Monitor Mode. Press the MON
key to enable monitoring. Up/down arrow keys
select any configured channel for monitoring.
When Channel 0 (Ω) is selected, touch the probe
tips together to measure test lead resistance.
Channel 10 (VAC) may have a small reading
because the input is unterminated. Press MON to
exit monitoring. [Figure 2-17]
Selecting the SCAN Mode. Press the SCAN
key to enable scanning. The display will indicate
which channel is being measured during the
scan. Monitor or Review can be enabled during
scanning. Measurement data can be routed to
the memory card, printer, or PC for display or
processing.
[Figure 2-15]
Selecting the Single Scan Mode.
SHIFT key, release, then press the SCAN key to
make a SINGLE measurement scan.
[Figure 2-15]
Ten Minute Tour (cont)
xvii
Ten Minute Tour
Press SCAN to exit scanning.
Press the
(continued)
op79_3f.eps