Table of Contents
Advertisement
2635A
Users Manual
G
LIST
CANCL
SHIFT
FILES
ENTER
CANCL
H
Setting the LIST Parameters. Press the LIST
LISt
key to open the LIST menu. LIST is used to print
out all the measurements from the Review Array,
dir
or print out a directory of all the files on the
memory card by selecting dir (Directory). To use
LASt
LIST, a printer (or PC) must be connected to the
RS-232 port. Press CANCL to exit. [Figure 5-4]
Setting the DESTINATION Parameter. Press
dESt
the SHIFT key, release, then press the FILES
key to open the MODE menu.
both
routes data to the memory card; Print (Print)
Print
routes data to the RS-232 connector to a printer
CArd
(or PC); both (Both) routes data to both
nonE
destinations, and nonE (None) to neither
destination.
[Figure 5-3]
Selecting the Destination Mode.
MODE
sends all measurement data to the destination
device (Memory Card in this example); ALAr
trAnS
(Alarm) send all measurement data to the
ALAr
destination device when any scanned channel is
ALL
in
measurement data to the destination device
when any scanned channel transitions into or out
of an alarm condition.
[Figure 5-3]
Ten Minute Tour (cont)
xxii
Select CArd and press ENTER.
alarm;
trAnS
(Transition)
Press CANCL to exit.
CArd (Card)
ALL (All)
sends
all
op79_8f.eps
Hide quick links:
Advertisement
Table of Contents
