Memory Card Data Extraction - Fluke Hydra Series II User Manual

Data bucket
Table of Contents

Advertisement

3/bAd is displayed (see Figure 2-16). Err4/bAd indicates the internal memory is full,
saving only the most recent 75 scans. The new card is updated with the scans in memory.

Memory Card Data Extraction

Measurement data recorded onto a memory card can be read only by a PC running
Starter or Logger applications software. If you want to have a copy of the measurement
data when it is being recorded, connect a printer during scan operations (see Chapter 5,
Printer Operation). If using a printer, verify the data destination is "both" (memory
card/printer) (see Figure 5-3).
SCAN ON
SCAN
Path to
OPEn
dAtxx
menu.
SCAN OFF
SCAN
SHIFT
SINGLE
SCAN
SCAN
Path to
OPEn
dAtxx
menu.
Starting the Scan Mode. Press the SCAN key to
SCAN
start scanning. If the data destination includes
the memory card and a data file has not been
CH
opened, a dAtxx file will be displayed. If an error
0:00:00
message appears, refer to Figure 2-16.
Opening a Data (dAtxx) File. Press ENTER to
OPEn
open the suggested file or use the cursor keys to
select a file name (00 to 99), then press ENTER.
dAtxx
If an error message appears, refer to Figure
2–16.
opening a file or starting scanning.
ENTER
Stopping the Scan Mode. Press the SCAN key
SCAN
again to stop the scan mode (-OFF- will be
displayed momentarily). If SCAN is pressed
- OFF -
during
measurements will be completed.
Starting the Single Scan Mode. Press the
SCAN
SHIFT key then then SCAN key for a single
measure-ment scan.
CH
includes the memory card and a data file has not
0:00:00
been opened, a dAtxx file will be displayed. If an
error message appears, refer to Figure 2-16.
Opening a Data (dAtxx) File. The suggested
OPEn
dAtxx file can be opened by pressing ENTER, or
the cursor keys can be used to select a file name
dAtxx
(00 to 99), then press ENTER.
message appears, refer to Figure 2-16. Press
the CANCL key to exit without opening a file.
ENTER
Figure 2-15. Using the Scan Mode
Front Panel Operations
Press the CANCL key to exit without
the
measurement
interval,
If the data destination
2
Operating Modes
the
If an error
op27f.eps
2-27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2635a

Table of Contents