Setup File Procedures; Using Setup Store - Fluke Hydra Series II User Manual

Setup File Procedures

Perform the following procedures to LOAD, STORE, and ERASE memory card
instrument configuration (SEtUP) files.

Using Setup Store

Perform the procedure in Figure 3-5 to save the current instrument configuration. The
communication parameters: baud, parity, CTS, and echo, remain as set previously by the
front panel controls or computer interface. The instrument automatically assigns the next
sequential SEtxx file name. When SEt99 is reached, the instrument loops back to reuse
previously assigned file names that have been erased or skipped over. To assign your
own file name, use the up/down and left/right arrow keys when creating the file.
FILES
ENTER
ENTER
ENTER
ENTER
Figure 3-5. Using SETUP STORE to Save Configuration Files
Selecting the SETUP mode. Press the FILES
FILES
key to access the FILES menu.
up/down arrow keys until SEtUP is displayed,
Init
then press the ENTER key. The menu changes
StAt
to SEtUP.
dir
Table 3-1.
dAtA
SEtUP
Selecting the STORE mode.
SEtUP
up/down arrow keys until StorE is displayed in
the SEtUP menu, then press the ENTER key.
ErASE
The menu changes to StorE and a file name is
StorE
displayed.
LOAd
Storing a SEtxx File.
StorE
SEtxx file name, where xx represents an
instrument-assigned number between 00 and 99
SEt99
or use the up/down, left/right arrow keys to select
SEtxx
the xx number. Press the ENTER key to store
SEt00
the file.
Overwriting a SEtxx File.
selected in the previous step is already assigned,
SUrE
the existing file will be overwritten with the new
file. If this is desired, select yES then press the
yES
ENTER key. If no is selected, the procedure will
no
terminate.
Table 3-1.
Typical
Required
Memory Card Operations

Setup File Procedures

If an error message appears, see
Press the
Record the displayed
If the xx number
If an error message appears, see
3
Press the
op41f.eps
3-9