Adjusting The Handle; Connecting The Instrument To A Power Source - Fluke Hydra Series II User Manual

2635A
Users Manual
•
•
•
Carefully remove the instrument from its shipping container and inspect the instrument
for possible damage or missing items. If the instrument is damaged or anything is
missing, contact the place of purchase immediately. Save the container and packing
material in case you have to return the instrument.
Rotate the rear feet of the instrument 180 degrees so that their support pads extend
slightly below the bottom of the case.

Adjusting the Handle

The handle can be positioned to four angles: one for carrying, two for viewing, and one
for handle removal. To change the angle, simultaneously pull both handle ends outward
to hard stops (about 1/4-inch on each side) and then rotate the handle to one of the four
stop positions shown in Figure 1-3. With the handle in the straight-up removal position,
you can disengage and free one handle side at a time.
1. Viewing Position
3. Carrying Position

Connecting the Instrument to a Power Source

The instrument can be connected to an ac or dc source. Connections are shown in Figure
1-4 and described below.
1-12
Line power cord
Type "T" Thermocouple
256K-byte Memory Card
2. Alternative Viewing Position
4. Removal Position
Figure 1-3. Adjusting the Handle
(to Remove, Pull Ends Out)
Pull One End Out and Towards You.
Then Pull the Other End Out.
Ω
COM V
300V
MAX
op03f.eps