Default Settings - SATO M-5900RV Operator And Technical Reference Manual

2.9 Default Settings

Switch Selections
All switches are placed in the Off position (default) for shipping. This will result in the
following operating configuration:
Communications:
Protocol: (1)
Sensor:
Receive Buffer:
Mode:
Label Sensor:
Backfeed:
External Signals:
(1) Active only if an RS232 Interface Card is installed in the printer.
Software Default Settings - The printer stores any software settings upon receipt
from the host and uses them until they are again changed by receipt of a command
containing a new setting. These settings are stored in non-volatile RAM and are not
affected by powering the printer off. The printer may be reset to use the default
software settings by depressing the LINE and .EED keys simultaneously while
powering the printer on. This will result in the following default configuration:
Once the default operation is completed, a DE.AULT SETTING COMPLETED
message will be displayed on the LCD panel and a single "beep" will be heard. The
printer should be powered off while this message is being displayed. This saves the
default settings in the EEPROM where they will be automatically loaded the next time
the printer is powered on.
PN 9001081
Rev. C
(1) 8 data bits, no parity, 1 Stop bit, 9600 Baud
Ready/Busy
Gap Sensor
Single Job
Batch Continuous
Sensor Used
Disabled
Disabled
P a a r m t e r e
r P t n i D a k r n e s s
r P t n i S p e e d
r P t n i R e e f e r c n e
Z e o r
A u o t O n L - n i e
SATO M-5900RV Operator and Technical Reference Manual
Section 2. Installation and Configuration
D e a f u t l S e t t
" " 3
3 . n i p r e s e
V r e c i t l a = 0 0 0 , 1 H o i r o z
S a l s h
E n a b e l d
DE.AULT SETTING
COMPLETED
n i g s
. c
n l a t = 0 0 0 1
Page 2-19