Automatic Measurement - Ecom J2KNpro Tech Operating Instructions Manual

Proceed as follows:
-Connect ecom-J2KN
-Select "Load data" and confirm with <OK>.
-Answer the displayed question with YES (<F1>).
-Decide if the data recorded can be cancelled
(<F1> for YES / <F4> for NO).
-Start the data transfer on your PC.
Send data:
With this function the data records completed with measurement
values can be transferred to the PC programme (procedure similar to
chapter „Load data").
Format:
This function is usually needed by the initial adjustment of the
instrument at our factory (preparation of internal memory for data
record).
Caution: All stored values will be cancelled!

14.2. Automatic measurement

The configuration of the ecom-J2KN
securing, self-regulating additional components like the condense
trap, the gas cooler and the magnetic valve technique permits even a
long term operation of the instrument. By setting time intervals for the
measurement the instrument switches autonomously to fresh air
purge after the measurement phase (gas will be sucked via the
connection fresh air) and operates a calibration phase for the
sensors.
This cycle repeats itself until the
automatic measurement will be finished.
For setting the time intervals select from
the menu "Data processing" the menu
item "Automatic measu.". The time
intervals have following meanings:
pro
ecom-
J2KN
pro
TECH and PC via USB cable.
TECH
pro
TECH with operation
Automatic measu.
Automatic
Data logger
Automatic time
Measurem. time
Save to MMC
CSV+Header
Quit with:
120 min
115 min
1 sek
Page 41