Installation - Yamaha YX600S Service Manual

~
I
3
FRONT eRAKE
!cHAsl~
I
INSTALLATION
1. Install:
•Master cylinder kit
CD
WARNING:
Internal parts should be lubricated with
brake fluid when installed.
•Circlip
~
•Dust boot@
2. Install:
•Master cylinder
•Brake hose (With copper washers)
•Brake lever
NOTE: ~~~~~~~~~~~~~~
Grease the pivot point.
3.
Tighten:
•Bolts (Master cylinder bracket)
•Bolt (Brake hose)
Bolts (Master cylinder bracket):
8 Nm (0.8 m•kg, 5.8 ft•lb)
Bolt (Brake hose):
25 Nm (2.5 m•kg, 18 ft•lb)
4.
Connect:
•Brake switch leads
5. Fill:
•Brake system
,ifh
Recommended Brake Fluid:
'U
DOT #3
6. Bleed the air completely from the brake
system.
Refer to "AIR BLEEDING" section.
7. Check:
•Brake fluid level
Refer to "CHAPTER 2-FRONT BRAKE
FLUID INSPECTION" section.
5-20