Set Alarms And Thresholds - Digi CM 8 User Manual

Power Controller
3 Select the port number of the serial port you want have connected to the power controller(s),
the manufacturer of the power controller, and the number of units to be cascaded (1 means that
one unit will be connected (no cascading)).
Note The number of cascaded units cannot be changed later, so make sure you have all power
controllers connected before proceeding.
The default title is the manufacturer brand and the port number it is connected to. You have the
ability to change this title in step 5 if needed.
4 Click Add controller.
5 After the controller is detected automatically, you can correct the number of ports if necessary
or edit the port title.
6 Click Save & apply.
7 Continue by setting the alarms and thresholds.

Set alarms and thresholds

Power Controller allows administrators to set an alert via email notification or an SNMP trap when
environmental conditions exceed specifications.
8 Under Power Controller click Alarms & thresholds.
9 Enter the appropriate parameters. Select the condition(s) for an alert and enter the information
for the alert (email, SNMP trap, or select both).
Digi CM User Guide

Set alarms and thresholds

123