Hardware information
Attribute
Dimensions
Weight
LED indicators
Use the LED indicators to confirm your attachment to the network and that the Digi CM unit is able
to send and receive data.
LED
System
Ethernet
Serial port*
*Not available on the Digi CM 48
About serial port cabling
The Digi CM unit simplifies cabling. The RJ-45 8-pin configuration matches all SUN and Cisco RJ-45
console port configurations, enabling CAT 5 cabling without pinout concerns. Three DB-25 and one
DB-9 adapters come in the package. A DB-25 male, a DB-25 female, and a DB-9 adapter support
console management applications. A DB-25 male adapter provides a modem connection. See the
cable adapter information that follows later in this chapter.
Note
The cable length restrictions common to RS-232 cables apply to the Digi CM serial cable as
well.
Digi CM User Guide
Value
9.5" x 6.25" x 1.25" (241.3 cm 158.75 x 31.75 cm)
2.5 lbs (1.13 kilograms)
Function
Power
On when power is supplied
Ready
On when system is ready to run
PC
On when a PC device is running
100Mbps
On when 100Base-TX connection is detected
LINK
On when connected to an Ethernet network
Act
Blinks when there is activity on the Ethernet port
In use
On when the serial port is ready to run
Rx/Tx
Blinks when there is traffic on the serial port
LED indicators
180