Reset Factory Defaults - Digi CM 8 User Manual

System administration

Reset factory defaults

There are two ways to reset the unit to the factory defaults. The quickest and simplest method is to
push and hold the hardware factory default reset button until the Ready light on the front panel
goes out. The reset button is located on the back panel of the unit next to the Ethernet port. The
arrow points to the reset button's location.
The alternative method to reset the unit is through the web interface. The web interface provides
the option of retaining the IP settings. To use the web interface to reset the Digi CM unit, do the
following:
1 Access the web interface.
2 System administration > Configuration management
3 Under Configuration import select Factory default.
.
1 Select the Configuration factory default options you want to restore from the checklist.
2 Click Import. The Digi CM unit will automatically reboot.
The following are the default values when the Digi CM unit is reset to the factory defaults.
▪
Static IP Address: 192.168.161.5
▪
Port Access Menu IP Address: 192.168.1.100
▪
Port Access Menu TCP Port Number: 7000
▪
Serial Port IP Address: 192.168.1.101-
Digi CM User Guide
Factory reset button

Reset factory defaults

Digi CM 32 shown
143