Ethernet electrical (EN 100) for
IEC 61850 and DIGSI
Ethernet optical (EN 100) for
IEC 61850 and DIGSI
1)
If the optical interface is required you must order the following: 11th Position 4 (FMS) or L0A (DP) and additionally:
For single ring: SIEMENS OLM 6GK1502-3AB10, for double ring: SIEMENS OLM 6GK1502-4AB10
The OLM converter requires an operating voltage of 24 VDC. If the operating voltage is > 24 VDC the additional power
supply 7XV5810-0BA00 is required.
Time Synchronisation Interface
Time synchronization
Connection for panel flush mounting housing
Connection for surface mounted case
Signal nominal voltages
Test voltage
U
6.0 V
IHigh
U
1.0 V at I
ILow
4.5 mA to 9.4 mA
I
IHigh
890 Ω at U
R
I
640 Ω at U
SIPROTEC, 7VK61, Manual
C53000-G1176-C159-3, Release date 05.2009
Connection for flush-mounted housing
For surface-mounted housing
Test voltage (female connector)
Transmission speed
Bridgeable distance
FO connector type
Connection for flush-mounted housing
For surface-mounted housing
Optical wavelength
Transmission speed
Laser class 1 according to
EN 60825-1/-2
Admissible optical signal attenuation
Bridgeable distance
DCF77/IRIG B signal (telegram format IRIG-B000)
Rear panel, slot „A"
9-pin D-subminiature female connector
At the double-deck terminal on the case bottom
Selectable 5 V, 12 V or 24 V
500 V; 50 Hz
Signal levels and burdens DCF77/IRIG-B:
5 V
15.8 V
= 0.25 mA
1.4 V at I
ILow
4.5 mA to 9.3 mA
1930 Ω at U
= 4 V
I
1700 Ω at U
= 6 V
I
Rear panel, mounting location "B" 2 x
RJ45 female connector 100BaseT acc. to
IEEE802.3
in the console housing at the console
bottom side
500 V; 50 Hz
100 MBit/s
20 m
ST connector receiver/transmitter
rear panel, mounting location "B"
Not available
λ = 1350 nm
100 MBit/s
Using glass fibre 50/125 μm
or
glass fibre 62.5/125 μm
Max. 5 dB, with glass fibre 62.5/125 µm
Max. 800 m
Nominal Signal Voltage
12 V
= 0.25 mA
ILow
= 8.7 V
I
= 15.8 V
I
Technical Data
4.1 General
24 V
31 V
1.9 V at I
= 0.25 mA
ILow
4.5 mA to 8.7 mA
3780 Ω at U
= 17 V
I
3560 Ω at U
= 31 V
I
235