Fisher & Paykel WH1260F1 Installation Manual page 9

Product dimensions
A
B
FRONT VIEW
PRODUCT DIMENSIONS
Overall height of product
A
Overall width of product
B
Overall depth of product
C
Depth with door open
D
Minimum door clearance to adjacent wall
E
Standpipe or spigot height
MAXIMUM CAPACITY
Note: the exact height of your washer is dependent on how far the feet are extended
from the base of the washer. The space where you install your washer needs to be at
least 40mm wider and 20mm deeper than its dimensions.
Electrical supply: 220 – 240V, 50Hz sinusoidal, minimum 10A.
● ●
Inlet water static pressure: Max. 1MPa (150psi), Min. 50kPa (7.2psi).
● ●
Inlet water flow rate at tap: Min. 8 litres/min.
● ●
A pressure-reducing valve must be installed if pressure is higher than 1MPa.
● ●
For optimum wash performance check the supply pressure is within the
● ●
recommended range.
INSTALLATION INSTRUCTIONS
D
(including dial and door when closed)
E
TOP VIEW
Wall
C
mm
850
600
665
1110
340
600 – 1000
kg
12
7