Fisher & Paykel WH1260F1 Installation Manual page 41

PROBLEM
Washing very
wet at the end
of the cycle
Vibrating
Creasing
TROUBLESHOOTING
POSSIBLE CAUSES
Cycle selected is not
appropriate for load.
Incorrect spin speed
for load selected.
An out of balance load
has occurred.
Transit bolts left in
place.
Washer may not be
level.
Load is out of balance.
Washer overloaded.
Incorrect cycle for load
type.
Spin speed too fast.
Wet clothes left in
washer or laundry
basket.
Wash temperature too
hot for load type.
Items not sorted
correctly.
WHAT TO DO
Particularly short or delicate cycles have
shorter spins which can result in wetter
washing at the end of the cycle.
Select a faster spin speed.
The washer compensates for being out of
balance by using a lower spin speed, to
reduce noise and potential damage to itself.
Ensure transit bolts are removed prior
to use of the washer (refer to 'Removing
transit safety bolts', page 5 and 6).
Ensure washer is installed on an appropriate
surface and levelled correctly (refer to
'Levelling the washer', page 8).
Wash an average sized load rather than
a smaller load or a single item. Washing one
item at a time is not recommended as it is
difficult for the washer to balance a single
item during spin.
Do not overload washer.
Use the 'Easy Iron' cycle for creasable items.
Select a slower spin speed.
Laundry left sitting wet is more likely to
crease. If not removing clothes from washer
immediately at end of cycle, select the 'Soil
Level' option. Do not leave wet washing
sitting in a washing basket.
Select a lower wash temperature.
Check items care label for correct care.
Check the hot and cold taps are connected
to the right valves (refer to 'Connecting to
the water supply', page 8).
Sort load so that items of similar weight are
washed together (refer to 'Sorting your
load', page 21).
39