Fisher & Paykel WH1260F1 Installation Manual page 33

Cleaning the inside of your washer
It is important that you regularly clean the inside of your
washer using the 'Drum Clean' cycle. After 100 cycles, a
notification will pop up on the display screen to remind you
to clean your washer. Carry out an additional 'Drum Clean'
cycle if your washer starts to smell. Remove any items from
the washer before you run this cycle.
To clean the inside of your washer:
We recommend the use of commercial washing machine cleaners only.
1
Add the washing machine cleaner to the 'Manual Dose' detergent compartment when
2
using 'Drum Clean' cycle.
Press 'POWER' to turn your washer on and select the 'Drum Clean' cycle.
3
Touch to start the cycle.
4
Cleaning the drum and the door
Use a soft damp cloth to wipe the door, cleaning any water marks or residue off it.
● ●
Wipe the rubber seal around the door. Remove any items or lint accumulating in the
● ●
bottom of the seal catchment and wipe out any water accumulated here. If this is not
cleaned out, unpleasant odours will develop.
If the drum has any residual dirt or lint stuck to it, remove this and wipe the drum clean.
● ●
Do not leave any metal objects in the drum as these may rust and cause staining.
The WH1260F1 model has a self cleaning door flush that directs a portion of the rinse
● ●
water over the door during various stages of the cycle to help to clean hair and insolubles
from the inside of the door and surrounding parts. We still advise that you manually
clean it with a soft cloth periodically as recommended in the instructions above.
CARING FOR YOUR WASHER
CLEAN DRUM
Drum has not been
cleaned for 100 cycles.
A 'Drum Clean' is
recommended
OK
31