Fisher & Paykel WH1260F1 Installation Manual page 39

PROBLEM
Washer drains
while filling
Washer is not
draining
Filling
continuously
Poor rinsing
Not spinning
properly
Too many soap
suds
TROUBLESHOOTING
POSSIBLE CAUSES
Drain hose too low.
Drain hose sitting in
water.
Drain hose blocked.
Pump filter blocked.
Drain hose higher than
1000mm above floor
level.
Drain hose not
connected to
standpipe or tub.
Washer siphoning.
Incorrect detergent
used.
Too much detergent
used.
Load has gone out of
balance.
Washer is not level.
Suds build up.
Incorrect type of
detergent used.
Too much detergent
used.
Inlet water pressure/
flow rate too low
WHAT TO DO
The height of the drain hose in stand pipe,
tub or spigot must be at least 600mm from
the floor level (refer to 'Draining', page 10).
Clear the drain.
Clear the drain hose.
Clear the pump filter (refer to 'Cleaning the
pump filter', page 32).
Lower the level of the drain hose (refer to
'Draining', page 10).
Connect drain hose correctly (refer to
'Draining', page 10).
Ensure standpipe or tub is at least 600mm
from the floor level.
Use low sudsing, front loader detergent only
(refer to 'Adding detergent and softener',
page 22).
If adding detergent in the manual dispenser,
ensure the correct dose of detergent is used
for the load size and soil level.
If using 'Auto Dose', reduce the dosage
by using 'Auto Detergent' (refer to
'Customising wash cycle', page 28).
Open door and redistribute load,
then restart the washer.
Ensure washer is correctly levelled (refer to
'Levelling the washer', page 8).
Check the amount of detergent used,
reduce if necessary.
Use low sudsing, front loader detergent only
(refer to 'Adding detergent and softener',
page 22).
If adding detergent in the manual dispenser,
ensure the correct dose of detergent is used
for the load size and soil level. If using 'Auto
Dose', reduce the dosage by using 'Auto
Detergent' (refer to 'Customising wash
cycle', page 28).
Ensure correct inlet water pressure and flow
rate as per installation instructions.
37