Fisher & Paykel WH1260F1 Installation Manual page 40

PROBLEM
Small puddle
of water from
under the
washer
Cycle time
longer than
usual/Inaccurate
time reading/
Adjustment of
time remaining
during cycle
Detergent
remaining
in manual
dispenser at the
end of the cycle
38
TROUBLESHOOTING
POSSIBLE CAUSES
Inlet hose or drain
hose leaking.
Lots of suds.
Dispenser
compartments
blocked.
Dispenser drawer not
fully closed.
Damage to door seal.
Wash time is
approximate.
Low water pressure or
flow rate.
Out of balance or
oversudsing.
Washing a large load.
Selecting various
options.
Dispenser drawer not
properly closed or
was opened part way
through the cycle.
Dirty or blocked
dispenser.
Dispenser overloaded
with detergent.
Composition of the
detergent makes it
difficult to dispense.
WHAT TO DO
Check inlet hoses and the drain hose are
correctly attached and not damaged.
Suds may have leaked and then dissolved.
Clean dispenser drawer (refer to 'Cleaning
the dispenser drawer', page 30).
Close dispenser drawer fully and ensure
it remains closed during the cycle.
Check seal inside door for damage.
If it sustains any damage it will need to
be replaced.
Wash time may be influenced by a number
of factors such as water flow rate, water
pressure, hot tap connection or reliance
on internal heater, load size, cycle and
option selections, as well as issues such as
oversudsing and out of balance.
Ensure that inlet hose filters are not blocked.
Recovery from out of balance or
oversudsing will extend cycle time (refer to
'User warnings', page 34).
Be aware that it will take longer for the
washer to fill.
Be aware that some options will extend
cycle time, eg 'Soak', 'Rinse+'.
Ensure the dispenser drawer is fully closed
at the start of the cycle and remains closed
throughout the cycle.
Clean the manual dispenser compartment.
Clean out remaining detergent (refer to
'Adding detergent and softener', page 22
for dosing information). Do not fill above
the MAX level.
Clean the manual dispenser compartment.