Before You Call For Service - Fisher & Paykel WH1260F1 Installation Manual

User warnings
Your washer is capable of self diagnosis and may sound a series of beeps and display a
notification or warning to inform you when there is a problem. In most cases you will be
able to address the problem the washer is alerting you to. Check this chart before you
call for service.
NOTIFICATION
DOOR OPEN
CLEAN DRUM
OUT OF
BALANCE
OVER-
SUDSING
DOOR IS
LOCKED
KEYLOCK ON
DETERGENT
LEVEL LOW
SOFTENER
LEVEL LOW
CLEAN FILTER
HIGH TEMP
WATER LEVEL
NO WATER
ADD A
GARMENT
34

BEFORE YOU CALL FOR SERVICE

WHAT TO DO
Close the door properly. Touch
to resume wash. Try opening and closing the door again.
Clean the drum. Select the 'Drum Clean' cycle and touch 'START/PAUSE'.
The reminder will display after every cycle, until the cycle is performed.
Touch to retry the spin.
If the warning persists, pause the cycle, manually redistribute the load
and touch to spin again. If necessary, stop the cycle, select 'Spin'
and touch .
If the problem persists, check that the washer is correctly levelled.
Wait for the washer to automatically restart when suds have dissipated.
When oversudsing occurs you may notice a reduction in performance.
Check you are using a detergent suitable for front loaders.
Check you are not overdosing the detergent.
Check the drain hose height does not exceed 1000mm.
The temperature in the drum is over 60°C therefore it is not safe to open
the door. Wait until the temperature drops below 60°C.
Check the water level in the drum. If the level is above the bottom of the
door seal, the door cannot be opened. Use the 'Add a Garment' button if
you wish to add or remove items.
If the drum is still moving, wait for it to stop before attempting to open
the door.
To disable, touch and hold the 'Keylock' button for 3 seconds.
Refill 'Auto Detergent' compartment or switch to 'Manual Dose'. Take care
to not fill beyond the MAX mark.
Refill 'Auto Softener' compartment. Take care to not fill beyond
the MAX mark.
The pump filter is blocked and needs to be cleaned. Follow instructions
on the label and refer to page 32 of this guide.
Door may remain locked due to high temperature in drum. Wait for temp
to reduce then try again.
Water level is too high. If this occurs, disconnect power and water and
contact Fisher & Paykel Customer Care.
Check taps have been properly connected and are turned on.
Wait for the door to unlock. The washer may need to lower its water
level and/or wait for a safer drum temperature before unlocking.
to confirm, and then touch