Fisher & Paykel WH1060P1 Installation Instructions Manual

Installation Instructions
Accessories
Check if you received the following accessories with your Fisher & Paykel washer. You will find them inside the drum or
attached to the packaging.
• 2 x Inlet hose(s)
• 1 x Inlet valve cap
• 1 x Drain hose guide
• 1 x Installation guide and User guide
• 1 x Spanner
• 1 x Installation leaflet (attached to the top of the washer)
Unpacking
To ensure the best performance from your new washer follow the instructions below.
Removing the Packaging
1. Remove the outer packaging (including the expanded polystyrene packer and plastic wrapping). All packaging
must be removed prior to use. Ensure these materials are kept out of reach of children. Note: a small amount of
water may be seen inside the packaging and inside the washer. This is the result of factory testing and is
normal.
2. Tilt the machine backwards and 'walk' it off the base one foot at a time. Not doing so may cause damage to
your floor and washer.
3. Remove all packaging and accessories from inside the drum.
https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/WashSmart/WH1060P1/User_Guide_WH1060P1/03_Installatio...
Updated: Mon, 06 Apr 2020 08:08:16 GMT
Powered by
1