Caring For Your Washer - Fisher & Paykel WH1260F1 Installation Manual

When you have finished using your washer
Unplug the washer from the power socket on the wall.
● ●
Wipe around the door and in the rubber gasket to remove any remaining water
● ●
and foreign matter.
Turn off the taps to prevent the chance of flooding should a hose burst.
● ●
Cleaning your washer
Before you start cleaning your washer, ensure that it is disconnected from the power
(ie unplug the washer from the power socket).
Cleaning the control panel and outer surfaces of the washer
Use a soft damp cloth to wipe all surfaces, then wipe dry. Avoid using chemical or
scouring cleaners, as these will damage the paint and plastic surfaces of your washer.
Cleaning the dispenser drawer
If you need to clean the dispenser, follow
the steps below:
To remove the drawer from the washer, pull
1
it open, push down on the release button to
the left of the 'Manual Dose' compartment
(refer to A), and pull it out from the washer.
– When handling the dispenser, ensure to
keep it horizontal to avoid spillage.
To empty the dispenser, turn the dispenser
2
upside down in the sink and allow the
leftover laundry liquid from the 'Auto
Dose' compartments to drain. To clean the
dispenser, fill the compartments with warm
water and shake lightly to clear residue.
Drain all water from the compartments
before re-fitting the dispenser to the washer.
IMPORTANT!
If a foreign object is inserted into the dispenser drawer compartments, the dispenser
drawer cover can be removed (see above). Unhook the two clips at the rear of the
dispenser to remove the cover. Ensure the dispenser drawer is correctly reassembled
before re-fitting the dispenser drawer to the washer. Any misassembly or damage to
the parts could result in malfunction of the product.
30

CARING FOR YOUR WASHER

Top view of
dispenser drawer
A