Installation Instructions - Fisher & Paykel WH1260F1 Installation Manual

Accessories
Check if you received the following accessories with your Fisher & Paykel washer.
You will find them inside the drum or attached to the packaging.
2 x Inlet hose(s)
● ●
1 x Inlet valve cap
● ●
1 x Drain hose guide
● ●
1 x Installation instructions and User guide
● ●
1 x Spanner
● ●
1 x Installation leaflet (attached to the top of the washer)
● ●
Unpacking
To ensure the best performance from your new washer please follow the instructions below.
Removing the packaging
Remove the outer packaging (including the expanded polystyrene packer and plastic
1
wrapping). All packaging must be removed prior to use. Ensure these materials are
kept out of reach of children. Note: a small amount of water may be seen inside the
packaging and inside the washer. This is the result of factory testing and is normal.
Tilt the washer backwards and 'walk' it off the base one foot at a time. Not doing so
2
may cause damage to your floor and washer.
Remove all packaging and accessories from inside the drum.
3
Removing transit safety bolts
The clothes washer is fitted with transit safety bolts at the rear to avoid possible damage
to the interior during transportation.
IMPORTANT!
The transit bolts MUST be removed prior to operation of the washer.
Failure to remove these will result in damage to the washer.
Note: the transit bolts MUST be removed in order to use the power cord.
To remove the bolts
Use a spanner or socket to unscrew and remove all 4 transit bolts at the back of the
1
washer (A).
Pull the black rubber grommets to remove the bolt, grommet and white plastic spacers
2
from the washer (B). Retain these for future use.
Removing the transit safety bolts

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS
A
B
5