Fisher & Paykel WH1260F1 Installation Manual page 13

Electrical connection
This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, minimum 10A
1
electrical supply.
Release the power cord (transit bolts must be removed).
2
Remove and discard the plastic pin cover and plug into a wall socket.
3
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
4
Check the power cord for damage and make sure it is not squashed or twisted when
● ●
installing the washer.
Always remove the power cord from a socket by the plug, not by the cord.
● ●
IMPORTANT!
If you are using an extension cord or a portable electrical outlet device
● ●
(eg multi-socket outlet box), ensure that it is positioned so that it does not come
into contact with water or moisture. FAILURE TO DO SO MAY RESULT IN DEATH OR
ELECTRICAL SHOCK.
Do not touch or operate the washer with wet hands or with bare feet.
● ●
A damaged power cord must be replaced by a Fisher & Paykel trained and supported
● ●
service technician or similarly qualified person in order to avoid a hazard. Do not use
the appliance until it has been repaired to avoid a risk of electric shock.
Do not operate this washer if it has been damaged during transport. Contact your
● ●
Fisher & Paykel dealer or Fisher & Paykel trained and supported service technician.
SPARE PARTS*
Hose inlet long (2m)
Hose inlet large bore
Drain hose extension (not suitable for attaching to a spigot)
*Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported service technician.
INSTALLATION INSTRUCTIONS
Part No.
422680P
426123P
425627P
11