How to use this
Safety
Mechanical
Electrical
Single line
Introduction
Parameters
Block diagrams
Diagnostics
Technical Data
Index
guide
information
installation
installation
descriptions
4
Mechanical installation
4.1
General installation
The installation of an Option module is illustrated in Figure 4-1.
Figure 4-1 Installing an Option module
1
2
4.1.1
Installing the first Option module
•
Option module slots must be used in the following order: slot 3, slot 2 and slot 1. Orientate the Option module above the drive as shown in (1).
Align and insert the Option module tab into the slot (2). Press down on the Option module until it clicks into place.
1
2
3
Adding Option modules: Populate slot 3 first, then slot 2 and finally slot 1
9
SI-I/O User Guide
Issue Number: 3