Table of Contents
Advertisement
FM-3 Programming Module Installation Manual
Basic Installation Notes
You are required to follow all safety precautions during start-up such as providing proper
equipment grounding, correctly fused power and an effective Emergency Stop circuit which
can immediately remove power in the case of a malfunction. See the "Safety Considerations"
section for more information.
Mechanical Installation
The FM-3 detects and verifies the drive serial number when its attached to an E Series drive.
If an FM-3 is moved from one drive to another, it will detect the difference in serial numbers
and generate an Invalid Configuration fault.
Two aligning tabs, a locking latch and a 100-pin connector are used to attach the FM-3 to an
E Series drive. All electrical connections between the FM-3 and the E Series drive are
accomplished with the single connector located on the rear of the FM-3.
1
Grip the FM
firmly on
each side.
Figure 3:
Attaching the FM-3 to an E Series Drive
Caution
Do not attach or detach the FM-3 when power is applied to the drive. It could cause drive
instability.
Continue pressing the FM
against the drive until the
latch clicks into the slot
on the top of the drive.
4
3
Gently press the
FM against the
drive, aligning the
100-pin connector.
2
Insert the
aligning tabs
into the slots
on the drive.
Get other manuals https://www.bkmanuals.com
Installation
3
Advertisement
Table of Contents
