Menu 1 - I/O Set-Up; Parameter - Emerson SI-I/O User Manual

How to use this Safety
Introduction
guide information
7.2

Menu 1 - I/O Set-up

Menu 1 contains all the parameters relating to the setup of the I/O interface on the SI-I/O module.
S.01.001 Reset I/O Interface
Minimum 0
Default 0
Type 1 Bit Volatile
Display Format None
Coding RW, NC
Changes to the module's configuration will not take effect until the module has been reset.
To reset the module:
• Set Pr S.01.001 to On (1).
• When the sequence has been completed, Pr S.01.001 will be reset to Off (0).
• The module will reset using the updated configuration.
NOTE
This sequence does NOT store the module's configuration parameters in the drive or the module's flash memory. This parameter will change back to
Off immediately, and as such the change may not be visible in the display.
S.01.002 Default I/O Interface
Minimum 0
Default 0
Type 1 Bit Volatile
Display Format None
Coding RW, NC
If the host drive is defaulted (see the drive user guide for details), it will also clear the current configuration for the slot the module is installed to.
This can be performed as follows:
• Set Pr S.01.002 to On.
• Reset the module by setting Pr S.01.001 to On.
• Default parameter values for the module will be loaded.
The module will reset using the default values.
S.01.004 Option Module Status
Minimum 0
Default
Type 8 Bit Volatile
Display Format None
Coding RO, TE, ND, NC, PT
This parameter displays the current status of the module. All possible values are shown in the table below.
Value Text
0 Running OK The module is healthy.
1 Initializing Indicates that the module is initializing.
Indicates that there is an error in the mapping parameters.
2 Mapping Error For example, the destination should not be non-existent or
read-only.
An error has occurred preventing the firmware or user
3 Error
program from running correctly.
100 Bootloader The bootloader is currently running.
The bootloader is currently performing a firmware update.
101 Updating
The power must not be turned off in this state.
18
Mechanical Electrical Single line
installation installation descriptions
Maximum 1
Units
Update Rate Read every 200 ms
Decimal Places 0
Maximum 1
Units
Update Rate Read every 200 ms
Decimal Places 0
Maximum 2
Units
Update Rate Background read
Decimal Places 0
Description
Parameters Block diagrams Diagnostics Technical Data Index
SI-I/O User Guide
Issue Number: 3