Analog Output (Terminal 11) In Current Output Mode; Relays (Terminals 21-23); Parameter - Emerson SI-I/O User Manual

How to use this Safety
Introduction
guide information
10.7

Analog Output (Terminal 11) in Current output mode

(Unidrive M600 - M800 only)
Type
Full scale output voltage range
Absolute maximum voltage range
Output resistance
Minimum load resistance
Maximum load resistance
Resolution
Maximum current
Offset
Maximum gain asymmetry
Update time
Isolation
10.8

Relays (Terminals 21-23)

Contact maximum current rating
Contact form
Update time
Category 1 installations must have suppression to limit supply-borne transients to a maximum of 1,500 V peak.
WARNING
38
Mechanical Electrical
installation installation
0-20 mA ± 1 %
±36 V
<200 Ω
200 Ω
600 Ω
12 bit
±30 mA short-circuit protected
±1 mA
0.1 %
2 ms
Not isolated from control circuit
Voltage rating
Single line
Parameters Block diagrams
descriptions
Monopole single-ended analog current output
240 Vac, Installation category II
2 A AC 240 V
5 A DC 30 V resistive load
0.5 A DC 30 V inducting load (L/R = 40 ms)
Closed when power applied
2 ms for Unidrive M600 - M800
8 ms for Unidrive M200 - M400
Diagnostics Technical Data
SI-I/O User Guide
Issue Number: 3
Index