Logging Into The Web Interface; Additional Information; Compliance Information - Patton SmartNode SN10100A Series Quick Start Manual

For debugging assistance, contact Patton's Support team at support@patton.com.
Once your IP Address and Time Zone are set, there are no more configuration steps in
the CLI and you may proceed to the web management page.
This section describes how to login and navigate the SmartNode 10100A Web Portal.
The first step involved in initially configuring any Smart Media system involves logging
on to the Web Portal. This can be divided into two distinct tasks: connecting to the
10100A via IP and logging on to the Web Portal. For establishing IP connectivity refer
to 8.2 "Accessing the SmartNode via the Ethernet Management port"
9.1 Connecting to the web server
Using a web browser, connect to the Web Portal by typing the following in your address
bar:
http://[DEVICE HOST NAME]:12358
–
or, alternately,
http://[DEVICE IP ADDRESS]:12358
–
9.2 Logging on to the Web Portal
In order to log on to the Web Portal configuration tool, enter the root user ID and pass-
word. The default values for these parameters are:
User ID: root
–
Default password: root
–
Refer to the following manuals–available online at www.patton.com/manuals–for
detailed information about installing, configuring, and operating the SN10100A models,
along with warranty, trademark, and compliance information.
SmartNode 10100A Series User Manual –
•
Smart Media System Software Configuration Guide –
•
SmartMedia-scg.pdf
A.1 Compliance
EMC:
10

9.0 Logging into the Web Interface

10.0 Additional Information

A.0 Compliance Information
www.patton.com/manuals/SN10100.pdf
www.patton.com/manuals/
SmartNode 10100A Series Quick Start Guide
on page 9.