Table of Contents
Advertisement
WORK-PIECE INSPECTION
CT180 is designed to sand wood only. Do
not use this machine to sand metals, glass
or stone etc.
Before sanding, make sure to inspect the
work-piece for nails, staples, small pieces
of stone or metal and any other foreign
objects.
Sanding the work-piece with this kind of
objects can tear the sanding paper. For a
safe sanding always inspect your work-
piece carefully before cutting and wear eye
protection.
Some woods with excessive finish or glue
load up the sand paper and reduce its
usefulness. Use an abrasive cleaner to
clean the sanding paper.
ADJUSTING THE
TABLE TILT
The work table can be tilted from 0° to 45°
by loosening the lock knob shown in figure-
16 and tilting the table to the desired angle
as indicated on the tilt scale and re-tighten
the lock knob.
Figure-16 Tilting the work table
HORIZONTAL/VERTICAL
SANDING
The belt sander can be positioned vertically
or horizontally and it can also be positioned
at any angle in between, depending on your
sanding needs.
TO ADJUST THE SANDING BELT ANGLE :
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Loosen the two lock nuts shown in figure-17
and slowly lift / lower the belt sander to the
desired angle.
Figure-17 Loosening the lock nuts
Re-tighten the lock nuts securing the belt
sander in position.
To position the belt sander horizontally,
lower the belt sander completely until it sits
on the stop bolt shown in figure-18.
Figure-18 Belt sander sitting on table stop
14
Advertisement
Table of Contents
