Table of Contents
Advertisement
EMS Bits per second
This feature sets the transmission speed for a serial port used in Con-
sole Redirection. Make sure that the same speed is used in both host
computer and the client computer. A lower transmission speed may
be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
EMS Flow Control
Use this feature to set the flow control for Console Redirection to pre-
vent data loss caused by buffer overflow. Send a "Stop" signal to stop
data sending when the receiving buffer is full. Send a "Start" signal
to start data sending when the receiving buffer is empty. The options
are None, Hardware RTS/CTS, and Software Xon/Xoff.
The setting for each of these features is displayed:
Data Bits
Parity
Stop Bits
System Agent (SA) Configuration
The following information will be displayed:
•
SA PCIe Code Version
•
VT-d Capability
PEG Port Configuration
PEG 0:1:0
Enable Root Port
Select Enable to activate the Root Port. The options are Disabled,
Enabled, and Auto.
Max Link Speed
Select Auto, Gen1, Gen2, or Gen3 to set the PEG Max Link Speed.
VT-d
This feature enables VT-d. The options are Disabled or Enabled.
4-33
Chapter 4: AMI BIOS
Advertisement
Table of Contents
