Table of Contents
Advertisement
2-4 M.2 Installation (optional)
Two M.2 (M-key) connectors are supported by the C9Z390-PGW. M.2
devices are used for solid state storage and internal expansion. Follow
the steps below in order to install an M.2 device.
1. Locate and remove the retaining
screws on the M.2 heatsink.
2. With the heatsink removed, locate
the standoff.
3. If required, remove the standoff
and move to appropriate location
for M.2 card's length.
4. Carefully plug the M.2 device into
the M.2 connector and lower the
semi-circle notched end onto the
standoff.
5. Remove the M.2 heatsink thermal
tape cover.
6. Replace the M.2 heatsink and
the retaining screws. Tighten the
screws to secure the heatsink into
place.
2-11
Chapter 2: Installation
Advertisement
Table of Contents
