Table of Contents
Advertisement
Supermicro C9Z390-PGW Motherboard User's Manual
Serial ATA Port0~5
Hot Plug
This feature designates the port specified for hot plugging. Set this item
to Enabled for hot-plugging support, which will allow the user to replace
a SATA disk drive without shutting down the system. The options are
Disabled or Enabled.
Spin Up Device
When this feature is disabled, all drives will spin up at boot. When this
option is enabled, it will perform Staggered Spin Up on any drive this
option is activated. The settings are Disabled or Enabled.
SATA Device Type
Use this feature to identify the type of HDD that is connected to the SATA
port. The options are Hard Disk Drive or Solid State Drive.
PCH-FW Configuration
Information for the following is displayed:
ME Firmware Version
ME Firmware Mode
ME Firmware SKU
ME FW Image Re-Flash
This feature enables an update to the PCH Firmware from an image in
a USB Flashdrive attached to a USB port. The options are Disabled or
Enabled.
USB Configuration
Legacy USB Support
Select Enabled to support legacy USB devices. Select Auto to disable
legacy support when legacy USB devices are not present. If Disable
is selected, legacy USB devices will not be supported. The options are
Disabled, Enabled, and Auto.
XHCI Hand-off
This feature is a work-around solution for operating systems that do not
support XHCI (Extensible Host Controller Interface) hand-off. The XHCI
ownership change should be claimed by the XHCI driver. The settings
are Disabled or Enabled.
4-38
Advertisement
Table of Contents
