KM 5773
3.59
Uneven Browning
Cause:
Unequal heat distribution throughout pot/pan.
Remedy:
Check heat distribution (induction only); see the general DTD, 26-0000.
3.60
Heat-Up Takes Too Long
Cause:
Pot/pan efficiency.
Remedy:
Check heat-up power (induction only); see the general DTD, 26-0000.
3.61
Pot/Pan Not Detected by Cooktop
Cause:
Pot/pan material.
Remedy:
Check the pot-detection feature (induction only); see the general DTD, 26-0000.
4
Service
4.1
Programming Mode Summary
Initial requirements:
Shut the cooktop off.
Accessing:
1. Press and hold the main switch touchpad.
2. At the same time, touch the lock $ touchpad three times briefly and hold on
the third time until the service programming mode is activated.
Note:
All user programming functions can also be accessed in service programming
mode.
Accessing the user programming mode: Shut the cooktop off, then press and
hold the main switch and lock $ touchpads together for 5 seconds.
Acknowledgement indicator:
The dot LED above the lock $ touchpad flashes at one-second intervals. The left
display shows P0 (programmable function 0). The right display shows S (state)
and the number for the current programmed state.
Options:
Note:
If a touchpad of no significance to the programming is touched, the programming
mode is quit without modifications being saved.
1. Touch the minus - or plus + touchpad of the front left burner to access the
desired programmable function (refer to Table 010-9).
45
Technical Information