Miele KM 5773 Technical Information page 27

KM 5773
Fault code
FE 32
FE 33
FE 34
FE 35
FE 36, FE 38
FE 39
FE 40 flashes
FE 40 solid
Cause Remedy
Ribbon cable between
Check ribbon cable and plugs between the
filter/control electronic
electronics on the side where FE is displayed and
and power electronic
replace as necessary.
defective
Check the power electronic on the side where FE is
displayed and replace it as necessary; refer to
Electronic fault Section 010-4.9.
Check the filter/control electronic on that side and
replace it as necessary; refer to Section 010-4.10.
Ribbon cable between
Check ribbon cable and plugs between the
filter electronic and
electronics on the side where FE is displayed and
power electronic
replace as necessary.
defective
Check the power electronic on the side where FE is
displayed and replace it as necessary; refer to
Section 010-4.9.
Electronic fault
Check the filter/control electronic on that side and
replace it as necessary; refer to Section 010-4.10.
Ribbon cable between
Check ribbon cable and plugs between the
filter electronic and
electronics on the side where FE is displayed and
power electronic
replace as necessary.
defective
Check the power electronic on the side where FE is
displayed and replace it as necessary; refer to
Section 010-4.9.
Electronic fault
Check the filter/control electronic on that side and
replace it as necessary; refer to Section 010-4.10.
Check supply voltage (208V or 240V between L1
Low voltage
and L2).
Connection fault Check power supply connection
Ribbon cable between
Check ribbon cable and plugs between the
filter electronic and
electronics on the side where FE is displayed and
power electronic
replace as necessary.
defective
Check filter electronic on the side where FE is
Filter electronic fault displayed and replace as necessary; see Section
010-4.10.
Selection electronic Check the selection electronic and replace as
defective necessary; see Section 010-4.6.
Disconnect and reconnect power.
Wiring harness Check the wiring harness (including plugs) between
between selection and selection and filter electronics and replace as
filter electronics open- necessary.
circuited
Check filter electronic and replace as necessary;
see Section 010-4.10.
Incorrect model version Program the correct model version; see Section
programmed 010-4.1.
Incorrect model version Program the correct model version; see Section
programmed 010-4.1.
Disconnect and reconnect power.
Check the wiring harness (including plugs) and
Wiring harness
between selection and replace as necessary.
filter electronics open-
Check selection electronic and replace as
circuited
necessary; see Section 010-4.6.
Replace filter electronic; see Section 010-4.10.
27
Technical Information