KM 5773
stopped and the burner switches off.
Cause:
The number of possible memory programs has been exceeded.
Remedy:
None. The cooktop is ready for use.
3.8
Fault Code F 99
Symptom:
While recording a memory program, F 99 is displayed. The memory record is
stopped and the burner switches off.
Cause:
The maximum time for a memory program has been exceeded.
Remedy:
None. The cooktop is ready for use.
3.9
Fault Code F Flashes Alternately with
Symptom:
The appliance does not heat. When a burner is switched on, fault code F flashes
alternately with
Cause:
Incorrect model programming.
Remedy:
Check the model programmed and, if necessary, program the correct appliance
model (refer to Section 010-4.1).
3.10
Fault Code FE 00, FE 04, FE 08, FE 12, FE 16, FE 76
Symptom:
At switch-on or after service programming, different fault codes in various
combinations are displayed.
Cause:
Incorrect model programming.
Remedy:
Check the model programmed and, if necessary, program the correct appliance
model (refer to Section 010-4.1).
3.11
Fault Codes FE 01 to FE 25
Symptom:
Fault code FE in power level display together with a number in the timer display,
for example, FE17.
Cause:
Soiling between the ceramic surface and the particular touchpad sensor (see
Table 010-8 for details).
Remedy:
Clean the area between the ceramic surface and sensor.
Cause:
.
31
Technical Information