Miele KM 5773 Technical Information page 26

Technical Information
Fault code
Hardware fault - In power level display: left F, right E
Fault code in timer display
FE 05
FE 06
FE 07
FE 09
FE 10
FE 11
FE 13
FE 14
FE 15
FE 17
FE 18
FE 19
FE 20
FE 21
FE 22
FE 23
FE 24
FE 25
FE 30 +
continuous
beep
FE 31
Cause Remedy
Sensor fault, - sensor,
rear left
Sensor fault, + sensor,
rear left
Sensor fault, booster
sensor, rear left
Sensor fault, - sensor,
center burner
Sensor fault, + sensor,
center burner
Sensor fault, booster
sensor, center burner
Sensor fault, - sensor,
rear right
Sensor fault, + sensor,
rear right
Sensor fault, booster
sensor, rear right
Sensor fault, - sensor,
front right
Sensor fault, + sensor,
front right
Sensor fault, booster
sensor, front right
Sensor fault, timer -
sensor
Sensor fault, timer +
sensor
Sensor fault, u sensor
Sensor fault, $ sensor
Sensor fault,  sensor
Sensor fault, M sensor
Connection fault: Check supply voltage
Secondary voltage of
Check supply connection terminal allocation
transformer-rectifier too
Check the filter electronic and replace as necessary;
high (primary voltage >
see Section 010-4.10.
300V)
Live (phase) L 2 not
Check power supply connection
available
Neutral N conductor
for right power Check that bridge between terminals 4 and 5 on
electronic not available terminal block is present and has good contact.
(bridge fault between Install bridge between terminals, if necessary.
terminals 4 and 5)
Ribbon cable between
Check ribbon cable and plugs between the
filter/control electronic
electronics on the side where FE is displayed and
and power electronic
replace as necessary.
defective
Check the power electronic on the side where FE is
displayed and replace it as necessary; refer to
Section 010-4.9.
Electronic fault
Check the filter/control electronic on that side and
replace it as necessary; refer to Section 010-4.10.
26
KM 5773